0) IP address: 192.168.1.6
1) Subnet mask: 255.255.255.0
2) DHCP: Disabled
3) Boot delay: 1 seconds
4) Reset to factory default configuration
5) Startup image: LAUNCH EXISTING
6) Program disk image into SmartMedia card: Enabled
7) Program DM9000 MAC address (10:23:45:67:89:AB)
8) Kernel Debugger: ENABLED
9) Format Boot Media for BinFS
B) Mark Bad Block at Reserved Block
D) Download image now(USE TFTP)
E) Erase Reserved Block
F) Low-level format the Smart Media card
L) LAUNCH existing Boot Media image
R) Read Configuration
U) Download image now(USE USB)
W) Write Configuration Right Now
我恍然大悟,原来这不是uboot而是eboot,然后我试着按U( Download image now(USE USB))碰碰运气,结果依然悲剧了
Enter your selection: u
USB host is connected. Waiting a download.
Addr: 0x3000000 ; Size: 0x357FA
+=OEMVerifyMemory+ dwStartAddr:0x0 dwLength:0x0
Don't support raw image
!OEMVERIFYMEMORY: Invalid image