##### Boot for TQ210 Main Menu #####
##### EmbedSky TFTP download mode #####
[1] Download u-boot.bin to Nand Flash
[2] Download Eboot (eboot.nb0) to Nand Flash
[3] Download Linux Kernel (zImage.bin) to Nand Flash
[4] Download LOGO Picture (logo.bin) to Nand Flash
[5] Download UBIFS image (root.ubi) to Nand Flash
[6] Download YAFFS image (root.bin) to Nand Flash
[7] Download Program to SDRAM and Run it
[8] Boot the system
[9] Format the Nand Flash
[0] Set the boot parameters
[a] Download User Program
[n] Set TFTP parameters(PC IP,TQ210 IP,Mask IP...)
[p] Test network (TQ210 Ping PC's IP)
[r] Reboot u-boot
[s] Download STEPLDR.nb1 to Nand Flash
[t] Test Linux Image (zImage)
[q] Return main Menu
Enter your selection: 1
dm9000 i/o: 0x88000000, id: 0x90000a46
DM9000: running in 16 bit mode
MAC: 00:40:5c:26:0a:5b
could not establish link
TFTP from server 192.168.1.103; our IP address is 192.168.1.80
Filename 'u-boot.bin'.
Load address: 0xc0008000
Loading: *
ARP Retry count exceeded; starting again
TFTP from server 192.168.1.103; our IP address is 192.168.1.80
Filename 'u-boot.bin'.
Load address: 0xc0008000
Loading: *
ARP Retry count exceeded; starting again
TFTP from server 192.168.1.103; our IP address is 192.168.1.80
Filename 'u-boot.bin'.
Load address: 0xc0008000
Loading: #################################################################
################
done
Bytes transferred = 409600 (0x64000)
NAND erase: device 0 offset 0x0, size 0x100000
Erasing at 0xe0000 -- 100% complete.
OK
NAND write: device 0 offset 0x0, size 0x64000
Main area read (4 blocks):
Checksum is calculated.
Main area write (4 blocks):
524288 bytes written: OK
##### Boot for TQ210 Main Menu #####
##### EmbedSky TFTP download mode #####
[1] Download u-boot.bin to Nand Flash
[2] Download Eboot (eboot.nb0) to Nand Flash
[3] Download Linux Kernel (zImage.bin) to Nand Flash
[4] Download LOGO Picture (logo.bin) to Nand Flash
[5] Download UBIFS image (root.ubi) to Nand Flash
[6] Download YAFFS image (root.bin) to Nand Flash
[7] Download Program to SDRAM and Run it
[8] Boot the system
[9] Format the Nand Flash
[0] Set the boot parameters
[a] Download User Program
[n] Set TFTP parameters(PC IP,TQ210 IP,Mask IP...)
[p] Test network (TQ210 Ping PC's IP)
[r] Reboot u-boot
[s] Download STEPLDR.nb1 to Nand Flash
[t] Test Linux Image (zImage)
[q] Return main Menu
Enter your selection:
|