|
具體的步驟就是照手冊說明 : 第九章 Android系统烧写
做完之後, MFGtool也出現綠色ok
然後把跳帽插回 1,2,5,6,7 pin
開機畫面一直在重複 android 然後就重開.
另外你們說明書第60頁有問題 !!
[1]ubuntu used emmc //设置默认从EMMC启动Android系统
這樣到底是啟動 ubuntu 還是android阿 ?
Kernel Log
--------------------------------
snvs_rtc snvs_rtc.0: setting system clock to 1970-01-24 23:20:40 UTC (2071240)
^[OFFreeing init memory: 240K
init: cannot find '/system/etc/install-recovery.sh', disabling 'flash_recovery'
camera_subdev: disagrees about version of symbol module_layout
root@android:/ # android_usb: already disabled
android_usb: already disabled
mtp_bind_config
warning: `rild' uses 32-bit capabilities (legacy support in use)
ov3640_write_reg:write reg error:reg=3012,val=80
ov3640_write_reg:write reg error:reg=3012,val=80
ERROR: v4l2 capture: slave not found!
ov3640_write_reg:write reg error:reg=3012,val=80
ERROR: v4l2 capture: slave not found!
ehci_fsl_bus_suspend begins, Host 1
ehci_fsl_bus_suspend ends, Host 1
request_suspend_state: wakeup (3->0) at 16561100338 (1970-01-24 23:20:53.526526003 UTC)
eth0: Freescale FEC PHY driver [Generic PHY] (mii_bus:phy_addr=1:00, irq=-1)
ADDRCONF(NETDEV_UP): eth0: link is not ready
acc_open
acc_release
ehci_fsl_bus_resume begins, Host 1
ehci_fsl_bus_resume ends, Host 1
usb 2-1: USB disconnect, device number 2
usb 2-1: new high speed USB device number 3 using fsl-ehci
hub 2-0:1.0: unable to enumerate USB device on port 1
ehci_fsl_bus_resume begins, DR
POR ]
*** Warning - bad CRC or MMC, using default environment |
|