真的存在linux2.6.37.2内核？

不是说，2.36的内核不支持yaffs2的补丁吗？不也能跑了;P

#####    Boot for Nand Flash Main Menu  #####
#####     EmbedSky USB download mode     #####

[1] Download u-boot or STEPLDR.nb1 or other bootloader to Nand Flash
[2] Download Eboot (eboot.nb0) to Nand Flash
[3] Download Linux Kernel (zImage.bin) to Nand Flash
[5] Download CRAMFS image to Nand Flash
[6] Download YAFFS image (root.bin) to Nand Flash
[7] Download Program (uCOS-II or TQ2440_Test) to SDRAM and Run it
[8] Boot the system
[9] Format the Nand Flash
[0] Set the boot parameters
[a] Download User Program (eg: uCOS-II or TQ2440_Test)
[b] Download LOGO Picture (.bin) to Nand  Flash
[l] Set LCD Parameters
[n] Enter TFTP download mode menu
[r] Reboot u-boot
[t] Test Linux Image (zImage)
[q] quit from menu
Enter your selection: 8
Start Linux ...
Copy linux kernel from 0x00200000 to 0x30008000, size = 0x00300000 ... Copy Kernel to SDRAM done,NOW, Booting Linux......
Uncompressing Linux... done, booting the kernel.
Linux version 2.6.37 (root@zengraoli) (gcc version 4.4.3 (ctng-1.6.1) ) #1 Tue Feb 22 07:34:02 CST 2011
CPU: ARM920T [41129200] revision 0 (ARMv4T), cr=c0007177
CPU: VIVT data cache, VIVT instruction cache
Machine: SMDK2440
Memory policy: ECC disabled, Data cache writeback
CPU S3C2440A (id 0x32440001)
S3C24XX Clocks, Copyright 2004 Simtec Electronics
S3C244X: core 400.000 MHz, memory 100.000 MHz, peripheral 50.000 MHz
CLOCK: Slow mode (1.500 MHz), fast, MPLL on, UPLL on
Built 1 zonelists in Zone order, mobility grouping off.  Total pages: 4064
Kernel command line: noinitrd root=/dev/mtdblock2 init=/linuxrc console=ttySAC0,115200
PID hash table entries: 64 (order: -4, 256 bytes)
Dentry cache hash table entries: 2048 (order: 1, 8192 bytes)
Inode-cache hash table entries: 1024 (order: 0, 4096 bytes)
Memory: 16MB = 16MB total
Memory: 11756k/11756k available, 4628k reserved, 0K highmem
Virtual kernel memory layout:
    vector  : 0xffff0000 - 0xffff1000   (   4 kB)
    fixmap  : 0xfff00000 - 0xfffe0000   ( 896 kB)
    DMA     : 0xffc00000 - 0xffe00000   (   2 MB)
    vmalloc : 0xc1800000 - 0xf6000000   ( 840 MB)
    lowmem  : 0xc0000000 - 0xc1000000   (  16 MB)
    modules : 0xbf000000 - 0xc0000000   (  16 MB)
      .init : 0xc0008000 - 0xc0028000   ( 128 kB)
      .text : 0xc0028000 - 0xc03ff914   (3935 kB)
      .data : 0xc0400000 - 0xc0424e20   ( 148 kB)
NR_IRQS:85
irq: clearing pending ext status 00080000
irq: clearing subpending status 00000003
irq: clearing subpending status 00000002
Console: colour dummy device 80x30
console [ttySAC0] enabled
Calibrating delay loop... 199.47 BogoMIPS (lpj=498688)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
gpiochip_add: gpios 288..303 (GPIOK) failed to register
gpiochip_add: gpios 320..334 (GPIOL) failed to register
gpiochip_add: gpios 352..353 (GPIOM) failed to register
NET: Registered protocol family 16
S3C Power Management, Copyright 2004 Simtec Electronics
S3C2440: Initialising architecture
S3C2440: IRQ Support
S3C24XX DMA Driver, Copyright 2003-2006 Simtec Electronics
DMA channel 0 at c1808000, irq 33
DMA channel 1 at c1808040, irq 34
DMA channel 2 at c1808080, irq 35
DMA channel 3 at c18080c0, irq 36
S3C244X: Clock Support, DVS off
bio: create slab <bio-0> at 0
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
Advanced Linux Sound Architecture Driver Version 1.0.23.
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 512 (order: 0, 4096 bytes)
TCP bind hash table entries: 512 (order: -1, 2048 bytes)
TCP: Hash tables configured (established 512 bind 512)
TCP reno registered
UDP hash table entries: 256 (order: 0, 4096 bytes)
UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
NET: Registered protocol family 1
RPC: Registered udp transport module.
RPC: Registered tcp transport module.
RPC: Registered tcp NFSv4.1 backchannel transport module.
NetWinder Floating Point Emulator V0.97 (extended precision)
JFFS2 version 2.2. (NAND) (SUMMARY)  漏 2001-2006 Red Hat, Inc.
ROMFS MTD (C) 2007 Red Hat, Inc.
msgmni has been set to 22
io scheduler noop registered
io scheduler deadline registered
io scheduler cfq registered (default)
Console: switching to colour frame buffer device 30x40
fb0: s3c2410fb frame buffer device
lp: driver loaded but no devices found
ppdev: user-space parallel port driver
Serial: 8250/16550 driver, 4 ports, IRQ sharing enabled
s3c2440-uart.0: s3c2410_serial0 at MMIO 0x50000000 (irq = 70) is a S3C2440
s3c2440-uart.1: s3c2410_serial1 at MMIO 0x50004000 (irq = 73) is a S3C2440
s3c2440-uart.2: s3c2410_serial2 at MMIO 0x50008000 (irq = 76) is a S3C2440
brd: module loaded
loop: module loaded
Uniform Multi-Platform E-IDE driver
ide-gd driver 1.18
ide-cd driver 5.00
S3C24XX NAND Driver, (c) 2004 Simtec Electronics
s3c24xx-nand s3c2440-nand: Tacls=2, 20ns Twrph0=6 60ns, Twrph1=2 20ns
s3c24xx-nand s3c2440-nand: NAND soft ECC
NAND device: Manufacturer ID: 0xec, Chip ID: 0xda (Samsung )
Scanning device for bad blocks
Bad eraseblock 168 at 0x000001500000
Bad eraseblock 860 at 0x000006b80000
Bad eraseblock 1372 at 0x00000ab80000
Bad eraseblock 2020 at 0x00000fc80000
Creating 3 MTD partitions on "NAND":
0x000000000000-0x000000040000 : "boot"
0x000000200000-0x000000500000 : "kernel"
0x000000500000-0x000010000000 : "yaffs2"
dm9000 Ethernet Driver, V1.31
usbmon: debugfs is not available
ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
s3c2410-ohci s3c2410-ohci: S3C24XX OHCI
s3c2410-ohci s3c2410-ohci: new USB bus registered, assigned bus number 1
s3c2410-ohci s3c2410-ohci: irq 42, io mem 0x49000000
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
usbcore: registered new interface driver libusual
usbcore: registered new interface driver usbserial
USB Serial support registered for generic
usbcore: registered new interface driver usbserial_generic
usbserial: USB Serial Driver core
USB Serial support registered for FTDI USB Serial Device
usbcore: registered new interface driver ftdi_sio
ftdi_sio: v1.6.0:USB FTDI Serial Converters Driver
USB Serial support registered for pl2303
usbcore: registered new interface driver pl2303
pl2303: Prolific PL2303 USB to serial adaptor driver
mice: PS/2 mouse device common for all mice
S3C24XX RTC, (c) 2004,2006 Simtec Electronics
S3C2410 Watchdog Timer, (c) 2004 Simtec Electronics
s3c2410-wdt s3c2410-wdt: watchdog inactive, reset disabled, irq enabled
ALSA device list:
  No soundcards found.
TCP cubic registered
NET: Registered protocol family 17
drivers/rtc/hctosys.c: unable to open rtc device (rtc0)
yaffs: dev is 32505858 name is "mtdblock2" ro
yaffs: passed flags ""
VFS: Mounted root (yaffs filesystem) readonly on device 31:2.
Freeing init memory: 128K
hwclock: can't open '/dev/misc/rtc': No such file or directory
/bin/qtopia: input_polldev: version magic '2.6.30.4-EmbedSky mod_unload ARMv4 ' should be '2.6.37 mod_unload ARMv4 '
line 23: can't create /etc/pointercal: Read-only file system
insmod: can't insert '/lib/input-polldev.ko': invalid module format
mac80211: version magic '2.6.30.4-EmbedSky mod_unload ARMv4 ' should be '2.6.37 mod_unload ARMv4 '
insmod: can't insert '/lib/mac80211.ko': invalid module format
rt2x00lib: version magic '2.6.30.4-EmbedSky mod_unload ARMv4 ' should be '2.6.37 mod_unload ARMv4 '
insmod: can't insert '/lib/rt2x00lib.ko': invalid module format
rt2x00usb: version magic '2.6.30.4-EmbedSky mod_unload ARMv4 ' should be '2.6.37 mod_unload ARMv4 '
insmod: can't insert '/lib/rt2x00usb.ko': invalid module format
rt73usb: version magic '2.6.30.4-EmbedSky mod_unload ARMv4 ' should be '2.6.37 mod_unload ARMv4 '
insmod: can't insert '/lib/rt73usb.ko': invalid module format
ts_open: No such file or directory
zd1211rw: version magic '2.6.30.4-EmbedSky mod_unload ARMv4 ' should be '2.6.37 mod_unload ARMv4 '
insmod: can't insert '/lib/zd1211rw.ko': invalid module format
ov9650: version magic '2.6.30.4-EmbedSky mod_unload ARMv4 ' should be '2.6.37 mod_unload ARMv4 '
insmod: can't insert '/lib/ov9650.ko': invalid module format
open device leds: No such file or directory
ifconfig: SIOCGIFFLAGS: No such device
ifconfig: SIOCSIFHWADDR: No such device
ifconfig: SIOCSIFADDR: No such device
route: SIOCADDRT: Network is unreachable
[01/Jan/1970:00:00:21 +0000] boa: server version Boa/0.94.13
[01/Jan/1970:00:00:21 +0000] boa: server built Jul 29 2009 at 14:27:34.
[01/Jan/1970:00:00:21 +0000] boa: starting server pid=949, port 80

Please press Enter to activate this console.

Linux version 2.6.37 (root@zengraoli) (gcc version 4.4.3 (ctng-1.6.1) ) #1 Tue Feb 22 07:34:02 CST 2011

这是亮点

嗯，建议网友把自己整理的路程和大家分享。
很好

2.6.36以上的fs.h改变很大，不知楼主是怎么怎么修改内核的，我修改yffs2，跑是跑起来，但有的时候一个ls就导致重启了。

3# embedsky_lxt


恩 等我整理一下 就好

4# embedsky_lhh


步骤其实也就这几部，ls导致重启我这里就不会啊。
这天忙补考，补考之后就能写移植文档了！呜。

等文档...............先谢过.................